The mesh belt dryer

Working principle:
Hui Yang - mesh belt dryer drying evenly on the mesh belt (compiled 304 stainless steel net), mesh belt with 8-100 mesh screen, stainless steel by gear drive mobile in the dryer. Dryer is composed of 4-20 units, each unit hot air circulation, independent part of the moisture by dedicated platoon is wet exhaust fan, exhaust gas is controlled by a control valve, the heat by go up or down by go up to the man under covered material mesh belt to complete the heat and mass transfer process, take material moisture. Mesh belt to move slowly, running speed can adjust freely according to the material temperature, drying after finished product continuous fell into the receiving device. Fluctuation cycle unit according to user needs can be equipped with a flexible, unit number to can be selected according to need.

USES:
Belt drying machine is commonly used for drying equipment, can be widely used in chemical, food, medicine, building materials, electronics and other industries, especially suitable for breathable good sheet, strip, dry granular material, the filter cake paste material, also can by pelleting machine or extrusion molding mechanism of article after drying. Typical products: hawthorn, dehydrated vegetable, granule feedstuff, monosodium glutamate, chicken essence, coconut, organic pigment, synthetic rubber, propylene fiber, medicine, traditional Chinese medicinal materials, small wood products, plastic products, aging and solidifying of electronic components, etc.
Features:
1, material wear by feeder evenly spread to the network, after filtration, purification, heat of the hot air from the circulation fan in the role of wind deflector through mesh belt and material layer, implemented in current hot air circulation drying, heat stability, uniform, full, improve material surface relative to wind speed and the heat exchange area, drying effect than the traditional parallel flow drying to improve a lot.
2, hot air recycling, ℃ temperature according to requirement of process unit can be controlled automatically, improves the thermal efficiency of a complete set of equipment, reduce the operation cost of the equipment, to ensure the economic benefit of users.
3, mesh belt speed and material thickness can make reasonable adjustment according to the laws of the heat and moisture to evaporate. From the feeding end to discharging end mesh belt speed gradually slow down, advanced material layer thickness increases gradually, ensures the retention period of material in drying chamber, make material of internal moisture migration in time to the surface, thus evaporation of moisture in time by the platoon is wet system pulls out, emptying. Final moisture content of material meet technological requirements of users.
Ordering information:
Name of the material liquid, property: % of moisture and the proportion of g/cm after, material form (composition of water, surface water).
Pieces after drying the final moisture content %, allowing the highest temperature ℃.
Mixer avoiding yield (kg/h) or fresh capacity (kg/h), class time h/day every day.
Availability for energy: steam pressure, capacitance kva, coal-fired stove, gas furnace.
Temperature at the inlet and outlet of the mixer control requirements: whether control is needed. Equipment material: stainless steel and Q235 carbon steel.
After-sales service:
(1) equipment installation and debugging
Equipment produced by the supplier after buyer's installation, debugging, notice, the supplier to send to wiring installation, debugging equipment.
(2) operator training
Operators since connection, debugging equipment, the buyer will be under the guidance of the supplier, learning equipment mechanical maintenance in the process of working principle and operating elements, using the theory of equipment and practical experience, to produce qualified products.
(3) equipment warranty
Equipment warranty for one year, all warranty period internal cause for the factors caused by equipment failure.
(4) technical services
Encountered in the use of technical problems, the supplier provide free technical services.
(5) after the guarantee period of equipment maintenance
Equipment problems after the expiration date, the supplier will provide high quality service and original accessories, fees in accordance with the unified the preferential price.