According to the air supply way and suitability classification:
1, horizontal air supply, is suitable for the objects to be placed on the tray bake; Horizontal air supply hot air is blown out by the studio on both sides, so the objects can be basked in the tray! Bake the effect will be very good. Instead, placed on the tray bake objects with vertical air supply is not suitable, vertical supply air blow out hot air is top-down, it blocked the hot air, thus hot bath is less than the following several layers, corresponding to bake the effect will be poor!
2, vertical air supply: suitable for baking placed on the rack, the objects on the vertical supply air blow out hot air is top-down, because be rack, whole and liquidity will be very good, make the hot air can be completely bathed in them! Placed on a rack items, of course, also can use horizontal air supply, it depends on the characteristics of the object itself!
The platoon is wet system
Fan: 1) the platoon is wet platoon is wet air quantity calculation by oven manufacturer, air volume adjustment methods: frequency conversion adjustment
2) the platoon is wet pipe: number 1 group
The drying chamber completion of heat and mass transfer, the temperature of the air temperature drop, increase air humidity, drying ability, should be timely discharge of exhaust gas, exhaust gas of the platoon is wet mouth summary to the platoon is wet after the main, part of damp heat exhaust by the platoon is wet system to fan negative pressure effect, in a timely manner to the outside; Another part of damp heat exhaust through the circulation fan mixed with fresh air, recycling again.
Due to the different temperature range of the moisture evaporation, the temperature OuDePai moisture content should be controllable and can be manually adjusted separately.
The drying temperature zone
System is divided into multiple convective drying units, multiple temperature zones respectively independent control. Multiple drying unit for the following distribution: temperature stage 1 unit and constant speed drying, 2 units falling rate drying unit, 1 check dry 1 unit. The calibration area is given, in the case of meet the demand of product is dry, material end-state status from the region.

And the wind device: all the boards

Spread width is about 0.3 m material according to the material, all the wind plate distribution of the 5 mm diameter hole, depending on the duct placed, to ensure that the material is heated evenly and drying efficiency. Using fast loading structure, all the wind can be easily loading and unloading, easy to clean.